In situ neutron diffraction study (300-1273 K) of non-stoichiometric strontium ferrite SrFeOx

The high-temperature cubic phase of non-stoichiometric strontium ferrite SrFeO_x (2.5≤x≤3.0) has been studied by in situ neutron powder diffraction in air over the temperature range 300-1273 K. The composition of SrFeO_x changes within the range 2.56≤x≤2.81 from 1273 to 673 K, respectively.Rietveld refinements of the diffraction patterns show that the high-temperature cubic phase of SrFeO_x is consistent with a face-centred Fm3c structure. This structure leads to agreement with previous density measurements. This cell allows the high-temperature structure of SrFeO_x to be described in terms of a solid solution of the composition end members. Cubic SrFeO_x at high temperature is found to closely obey Vegard's law. The density of cubic SrFeO_x is also found to exhibit a linear relationship with composition.     

一维光学格子孤子的传输特性及控制研究

利用解析和数值方法研究了在具有横向折射率周期性调制的克尔型非线性介质中光学格子孤子的传输，得到了孤子参数的演化方程以及格子孤子的形成和稳定传输的条件.结果表明：当光束的入射角小于某临界角度时，光束可被类似波导形式的路径俘获而稳定传输，该临界角随折射率调制周期、调制深度的增加而增大，且光束越窄临界值越大.此外，线性空间啁啾虽然对光束传输的中心位置没有任何影响，但会导致光束发散从而破坏格子孤子的形成和稳定传输，对此提出了采用特定功率取值来补偿啁啾作用从而形成格子孤子的方案. 关键词： 光孤子 光学格子 光传输 矩方法     

约束层对激光驱动冲击波压力影响机理的理论研究

针对刚性约束层、柔性约束层以及液体约束层，从激光诱导冲击波阵面状态、汽化物(包括气体和等离子体)扩散以及冲击波的反射进行分析，发现对于脉宽小于冲击波通过汽化物层的时间间隔的短脉冲激光，约束层并不能直接提高冲击波的冲量，而对于脉宽大于冲击波通过汽化层时间间隔的激光，其增强冲击效果是通过约束汽化物的扩散，提高压力幅值和由于冲击波在约束层与工件表面的多次反射而延长对工件的作用时间来实现的.刚性约束层能最大地增加冲击冲量，而柔性约束层和液体约束层的主要优点是其形状可与非平面形工件表面符合. 关键词： 激光 约束层 扩散 反射波     

激光二极管反馈干涉的实验观测

利用LabView软件虚拟示波器和信号源,观测了激光二极管反馈干涉实验现象．实验证明反馈回激光二极管的光的入射方向和入射光强以及信号处理电路的带宽,对反馈干涉信号有很大的影响．     

ω-meson photoproduction on nucleons in the near-threshold region

The European Physical Journal A - The ω-meson photoproduction, γ + p→p + ω, is studied in the framework of a model, containing π-meson exchange in t-channel and...     

基于同步辐射加速器的康普顿背散射γ射线源(Ⅰ)产生MeV量级γ光子的数值计算

提出在筹建的上海同步辐射装置上建造一条MeV量级γ射线束及应用站,采用μm波长的红外(或远红外)激光与储存环中3.5GeV电子束进行康普顿背散射,从而获得能区为1—25MeV的康普顿背散射γ光子束,该光子束具有高强度、高极化度(线和圆极化)、准单色、方向性好的优点,可以广泛地应用于核物理和核天体物理基础研究及相关的应用研究领域.介绍了康普顿背散射的基本原理,并结合储存环参数给出了光子束性能的数值计算结果.     

Active long pulse shaping technique of pulsed CO2 laser using multi-pulse discharge control

We describe the pulse forming of pulsed CO₂ laser using multi-pulse superposition technique. Various pulse shapes, high duty cycle pulse forming network (PFN) are constructed by time sequence. This study shows a technology that makes it possible to make various long pulse shapes by activating SCRs of three PFN modules consecutively at a desirable delay time with the aid of a PIC one-chip microprocessor. The power supply for this experiment consists of three PFN modules. Each PFN module uses a capacitor, a pulse forming inductor, a SCR, a high voltage pulse transformer, and a bridge rectifier on each transformer secondary. The PFN modules operate at low voltage by driving the primary of HV pulse transformer. The secondary of the transformer has a full-wave rectifier, which passes the pulse energy to the load in a continuous sequence.We investigated various long pulse shapes as different trigger time intervals of SCRs among three PFN modules. As a result, we could obtain laser beam with various pulse shapes and durations from about 250 to 1000 μs.     

光纤光栅激光器激射波长的研究

一般认为，用光纤光栅作选频元件的光纤激光器，激射波长与光纤光栅中心反射波长一致，本文报道了不同的实验研究结果。通过细致的实验研究，发现光纤光栅激光器激射波长相对于光纤光栅中心反射波长有一定的偏移。激射波长可以出现在光栅中心反射波长的长波端，也可以出现在其短波端。对不同腔结构的掺镱、掺铒光纤光栅激光器的深入研究证明，谐振腔的各向异性对激光器的激射波长偏移起到决定性的作用，波长最大偏移量主要受限于光纤光栅的反射带宽。通过激光腔内的偏振控制器改变谐振腔的各向异性，可以在光纤光栅的反射带宽内控制激射波长的位置。